Machine oil can chemical barrel cleaning and recycling equipment
Name: Machine oil can chemical barrel cleaning and recycling equipment
Model:
Raw material:
Usage:
Main machine:
Source material: Waste HDPE chemical barrel (≤200L) Ingredients: 1, the barrel body: HDPE high density polyethylene; 2. Bucket cover: HDPE high-density polyethylene; 3. Label: adhesive label paper; 4, residual: conventional solution liquid, hydrophilic, residual rate is not more than 5%; 5, impurity: a small amount of sediment on the surface of the barrel. For 200 l barrels of volume is larger, and the round state, the crusher efficiency is low and not easy to discharge, Po plastic design solutions to chemical barrels into the four axis shredding machine crushed at the beginning of processing, up to 50 mm Ø around flake, torn the plastic by slipped to the spiral feeding machine fell out of the screen (the residual liquid and rinse water by feeding machine mesh filter out centralized collection). Send to sink and float separation for acid-base neutralization, if there is a bottom of plastic and metal will sink from the bottom of the slag spiral out, here can be used to add circulating water to the tank for acid-base neutralization, the main effect is to reduce the plastic sheet carried by the acid and alkaline liquid on the equipment corrosion. The neutralized plastic sheet is taken out by the roller, and sent into the plastic crusher by the screw feeder for refinement and crushing treatment, and broken to Ø16mm(meet the requirements of deep cleaning and granulation sheet diameter). When crushing, a certain amount of water is added. After crushing, it is sent to the powerful friction machine by the screw feeder for powerful friction cleaning and decontamination. In the friction, an appropriate amount of cleaning agent is added for auxiliary cleaning, which can effectively remove stubborn residues and impurities. (If the chemical raw material barrel contains more residual solution, it can be used to add a group of secondary clean water friction cleaning and secondary clean water rinsing). After rubbing, the material is dropped into the rinsing tank for rinsing. After rinsing, the plastic sheet roller is sent by the screw feeder to the high-speed dehydrator for dehydration and to the storage tank for packaging and then to the granulator. Finished products can be identified in accordance with the identification standard for hazardous waste - identification of leaching toxicity (GB 5085.3-1996).
Model | Capacity | Total power | Water consumption | Floor area | Factory requirements |
PTC-500W | 500KG/H | 78kw | 6m³/h | 50M×3.2M×4.5M | ≥800m² |
PTC-1000W | 1000KG/H | 150kw | 10m³/h | 70M×3.2M×4.5M | ≥1500m² |
PTC-2000W | 2000KG/H | 220kw | 20m³/h | 80M×3.8M×4.5M | ≥2500m² |
Note: The above index data are only for parameters, and the specific index is subject to the data in the proposal. |
Main equipment:
|
Mobile site
Official WeChat